roverworx

Specializing in expedition quality gear and service to get where you're going... and get back.

Home of Rivet the 101FC

The overhead console in Rivet

It has:	2 Hella fans 6 LR switches Stereo Oil pressure gauge Transfer case temperature gauge Air/fuel mixture gauge 2 LED lamps Front and rear interior flood lights Mag lite holder 2 front speakers (4 inch with 300 Hz bass blockers) Rader detector (not that it's needed) Compact CB radio
	This is the front of it. The sides are storage areas.
	With the fans up...
	And the fans down.....
	This is the front and rear parts. The storage areas can be seen too. The front and rear worklight are controlled with the switches.
	Another shot of the console.
	The console is controlled by a 7 fuse circuit from Painless Wiring as well as 5 relays. The are mounted on a standoff panel that is about an inch away from the body. The other speaker is mounted the same way (no relays and stuff though).
	Here are the 6 LR switches.
	This is the wiring from the backside.
	The custom stereo mounting bracket can be seen here.
	This is the stereo face. The rivets below are hooked to the mounting brackets.
	This is what the front looks like before installation
	Here is the back.
	The console compliments the dash gauges

For addition pictures of the construction and parts - click here. The console was created with 0.063 in aluminum. I used a 3003 alloy for it

roverworx.com